Lubricate all the hangers and rubber isolators. Figure 2 5. Using a muffler stand or an additional person to hold the exhaust system up in place, remove the hangers from the rubber isolators and then remove the entire exhaust system from the vehicle as shown in figure 4. Warning: Use extreme caution during installation. Use of such tools may result in bent flanges or gasket contact areas leading to exhaust leaks.
Using the original hardware, place the left and right front pipe assemblies into position as shown in figure 5. Hand tighten the hardware for now. Apply anti seize to the oxygen sensor threads and install the oxygen sensors into each front pipes. Torque the oxygen sensors to ft. Figure 4 3. Place a clamp over the expanded end of the front muffler assembly and set it into position as shown in figure 6. Do Not tighten the clamps. Place a clamp over the expanded ends of the muffler assembly and set it up into position as shown in figure 6 making sure to install all the hangers into the rubber isolators.
Using the original hardware, re install the center support bar. Figure 5 5. Place a clamp over the expanded ends of both left and right intermediate pipes and set them into position as shown in figure 7.
Place a clamp over the expanded inlet of the left and right rear muffler assemblies and set them into position as shown in figure 8 making sure to install the hangers into the rubber isolators. Check your exhaust system for proper clearance under the vehicle and also for tip alignment. Figure 6 8. Before starting your vehicle, make sure to check all wires, hoses, brake lines, body parts and tires for safe clearance from the exhaust system. Start vehicle and check for any leaks.
Engines varied wildly from a modest 2. This site is part of the GimmeManuals. Skip to content Home Search Submit. Yearly STS Owner's Manuals The years available stretch from through to and to view the manual you just click the name underneath. Transmissions were always automatic in the form of 5 or 6 gears and trim options included: Luxury Luxury Sport Performance Premium V. The buttons are located on the climate control panel. Press the up arrow once to turn on the heated seat at the highest setting.
Press the down arrow once to turn on the heated seat at the lowest setting. Pressing the up or down arrows a second time will raise or lower the setting. To turn off the heated seat keep pressing the down arrow until the indicator for heated seat on the climate control display is off.
A light bar in the climate control display shows the setting: high, medium, or low. The longest bar shows the high range and the shortest bar shows the low range. The heated seat will automatically shut off when the vehicle is turned off. There are three settings for each feature. A light bar in the climate control display shows the setting; high, medium or low.
Pressing either the heated seat or ventilated part of the seat button will start that feature at the highest setting. Each time you press the button, the feature will decrease one setting. To turn the feature off, keep pressing the button until the display lights turn off. The heated or ventilated seats will automatically shut off when the vehicle is turned off.
Power Reclining Seatbacks The front seats have power reclining seatbacks. Use the vertical power seat control located on the outboard side of the seat to operate them.
G Owners Manual online. Car Manuals Online.
0コメント